Hello all, i bought this buck rivet gun over ebay and was told it had a .498 shank (which i geuss it does!) the seller sent me a few different bits for the gun but some were only .401 shanks so i ordered a 5/32 bit with a .498 shank and when i came to use it the spring which goes over the gun is too small for the shank, could i just take a couple of rounds off the spring? to solve this problem, also to buck countersunk rivets do you use the flat bits??. i geuss using it without the spring would put this piece of kit in the league of a lethal weapon, i've attached some photo'S please any thoughts
0 comments:
Post a Comment